Step 4: Install the Two Supporting Studs
Install the two studs (2” x 4” x 12”L) on the left side and right side of
the opening, behind the drywal
l (Figure 2).
Drive three
sc
r
ews
#10
(
1 1/2"
L
)
through the drywall into each stud on both sides (total of six screws to be
used).
Step 5: Install the
Picture-Frame p
anel and the
d
ispenser into the
w
all
.
Remove the protecting film on the outside of the panel. Recommend to
use
cotton gloves to handle the panel after the film is removed to avoid finger
prints.
Carefully place the dispenser into the big opening on the panel. Then install
the assembly (of the cover and the panel together) into the opening on the
wall. Slide the dispenser all the way in; ensure there is no gap between the
panel and the wall.
Use the key (provided) to open the cover. Drive four #
10
screws (
also
provided) into the mounting holes on the left and right sides of the dispenser
to secure the dispenser
in position. S
ee
Figure 3 for more details.
The dispenser is now ready for Roll Support installation and paper loading.
Figure
2
.
Figure
3
.
PICTURE-FRAME
PANEL
screw# 10 in step 4
mounting holes
inside the
dispenser
supporting studs
877
7
002
Released
February
22
201
9
3
