1
Disclaimers
PV Module Monocrystalline Bi-Facial Module Installation Guide
Disclaimers
Important Notice
Copyright © SolarEdge Inc. All rights reserved.
No part of this document may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means,
electronic, mechanical, photographic, magnetic, or otherwise, without the prior written permission of SolarEdge Inc.
The material furnished in this document is believed to be accurate and reliable. However, SolarEdge assumes no
responsibility for the use of this material. SolarEdge reserves the right to make changes to the material at any time and
without notice. You may refer to the SolarEdge website (
) for the most updated version.
All company and brand products and service names are trademarks or registered trademarks of their respective holders.
Patent marking notice: see
http://www.solaredge.com/patent
The general terms and conditions of delivery of SolarEdge shall apply.
The content of these documents is continually reviewed and amended, where necessary. However, discrepancies cannot be
excluded. No guarantee is made for the completeness of these documents.
Please note: This product is intended to provide remote shutdown of the SolarEdge PV harvesting system, to enable safer
access to a building in the event of a fire. This product DOES NOT reduce the risk of fire or protect firefighters or others
accessing a building in the event of a fire.
The images contained in this document are for illustrative purposes only and may vary depending on product models.
Emission Compliance
This equipment has been tested and found to comply with the limits applied by the local regulations.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, you are encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance may void the user’s authority to
operate the equipment.
Summary of Contents for PV530-R72LGML
Page 20: ......