Solar EV Systems SEV36-8-WP, Manual

Page: 1 / 4

Tools & Requirements for Install:

Wire Cutter / Stripper
o
(12/14/16 gauge stranded)

Insulated Connector Wire Crimper

Heat Gun for heat shrink

Digital Multi-meter (to measure DC
– Voltage / Current)
Installation
To connect to your battery - open your battery compartment under the
drivers / passenger seat and locate the
main battery terminals that provide
the car with 48 or 36 volts DC. Diagram is on page three (3).
WIRING Connections:
Solar Panel Connection (Solar EV Cable):

Panel Cable Red is + / Positive to Yellow Wire - Controller

Panel Cable Black is - / Negative to Black Wire - Controller
Battery Connections:

Positive (Red) w/ Fuse Holder

Negative (Black)

Always Cut and Crimp / Connect EACH WIRE INDIVIDUALLY

Heat-shrink each connector carefully to not melt the individual wires

You may experience a spark when connecting the controller to
the main battery terminals
– this is 100% normal – the controller
does hold a charge from the built in capacitors.