10
rev.1011 MKTG-IM-TP-34-002
Installation and Owner’s Manual | TP Series Solar LED Lighting System
2.8 Attaching the LED Fixture to the Arm
Two types of LED fixtures are provided with the SH Series lighting system:
Attaching the Ascot Fixture to the Arm
1.
Loosen fastener that secures hinged cover to fixture; lift cover and loosen
mounting clamp bolts. Route the connector wire from the mounting arm through
the fixture mounting clamp, and plug luminaire connectors together (11a).
2.
Slide the fixture mounting clamp over the mounting arm (11b) and adjust the
angle by positioning the fixture so the appropriate tilt step rests on the end of the
mounting arm (11c).
3.
Tighten the mounting clamp bolts (do not over tighten) to secure the fixture to
the mounting arm then close the hinged cover and secure it to the fixture).
Attaching the Shoebox Fixture to the Arm
1.
Loosen the two set screws on the Shoebox fixture (Figure 12a).
2.
Plug the Shoebox fixture connector into the load cable connector.
3.
Slide the Shoebox fixture over the arm. Feed any excess load cable back into
the arm while sliding the fixture over the arm.
4.
Remove the circular cover (using a Phillips screwdriver) and loosen the bolt
(using a socket wrench) to change the angle of the fixture (Figure 12b). Tighten
the bolt and replace the cover when completed.
FIGURE 12
ATTACHING THE SHOEBOX FIXTURE TO THE ARM
(a)
(b)
Set Screws
FIGURE 11
ATTACHING THE COBRAHEAD
FIXTURE TO THE ARM
(a)
(b)
(c)
Cobrahead
Fixture
Shoebox
Fixture
