36
9. TROUBLESHOOTING
●
Pressing the POWER button
does not switch ON the power.
→
Check that the battery has been inserted.
Replace the battery.
C
"7.1 Using the Battery"
●
The total station does not perform Turning operation even when distance measure-
ment is executed.
→
The Turning operation setting of the total station is deactivated.
Set the "Srch method" setting for the SRX/NET to "R.C.".
C
"6.2 Settings for Auto Pointing and Auto Tracking"
→
A connection has not been established with the total station.
Check the pairing settings and communication conditions for the total station and RC-Controllers
being used.
C
"6.1 Settings for Bluetooth Communication", "7.2 Configuring Bluetooth Connections to the
SRX/NET"
●
Turning operation failure
→
The beam detector cover is closed.
Close the beam detector cover.
→
Both the laser projection port and the prism are not pointing in the direction of the total station.
Point the laser projection port and the prism towards the total station.
→
The total station cannot receive the beam emitted from the RC-Controller as the amount of light is
too low.
Check that the Distance Mode setting is correct.
C
"7.3.2 Setting Distance Mode"
→
Turning operation has located the horizontal position but cannot find the vertical position.
Turning operation for the vertical position cannot be performed while the pole is tilted at an angle.
Check that the pole is fixed in the correct position, vertically over the measurement point.
→
Check that there are no obstacles between the beam detector of the total station and the laser
projection port of the RC-Controller/prism.
→
Flat white surfaces in close proximity to the optical path between the total station beam detector
and RC-Controller laser projection port may reflect the emitted laser beam and
cause Turning operation failure. Have someone stand in front of such objects or otherwise cover,
such as with a dark-colored cloth.
→
There is dust or dirt on the beam detector/laser projection port.
Dust off minute particles with the lens brush before carefully wiping with the cleaning cloth.
●
Total station finishes Turning operation pointing in the wrong direction.
→
The total station receives the emitted laser beam after it has been reflected off a highly-reflective
surface in the vicinity of the RC-Controller.
Continue Turning operation.
C
"4.2 Measurement Flow"
C
"6.3 Performing Turning from the SRX/NET"
