Sojet Elfin IC, User Manual, Page: 40 / 41

34
Appendix 1: Terms and Definitions
Sr.# Term Definition Comment
1
Printing delay
It is the distance from the point when
photocell senses the printing object
to the point when printing starts.
User can adjust the value to alter the
print position on printing object.
E.g. Printing delay value is 30mm,
printer starts printing at 30mm point after
the photocell senses the printing object.
2 Printing
initial value It is beginning value in printing
process for print data. E.g. Set the initial value as 9, the counter
counting starts from 9 for first print.
3
Screen
saver time
It is a power saving function, the
screen will automatically turn off and
enter standby mode when the screen
is inactive for a time period as set. E.g. Set the screen saver time as one
minute. The screen will automatically
turn off and enter standby mode if the
screen becomes inactive for one minute.
4
Customer
year
It is the special year on customer
demand. Customer can change the
year in date format by any round
number within scope.
E.g. The system date is 2012/07/31.
Supposed the date by customer is
2010/07/31, customer can set the year in
date as 2010. Then the date shown on
the print will be 2010/07/31.
5
Date
transition
time setting
When system time reaches certain
point, the printout date and time will
be that of the next date.
For example: Current date is 07.10, set
the date transition time to be 07:59,then
the time of last printing out before that is
recorded as 09/07 07:59, after that is
10/07,8:00. If the date transition time is
12:01,then the time of last printing out
before that is recorded as 10/07
12:00,after that is 11/07.
6 Pre-purge
Ink becomes dry on nozzle plate
during use. The dried ink will make
the print not clear for half of first
character. To prevent this
phenomenon, user can turn this
function ON. When Pre-purge function is turned ON,
printer will spray a little ink at optioned
level during idle period in printing
process to keep nozzle plate warm and
moist so as to eliminate dried ink
phenomenon.
7
Clean
Printhead
Customer can use this function to
purge nozzles. Purge whole nozzle plate, make sure
nozzles are unblocked.
8
Channel
switch
Customer can switch for different
channel to achieve best print quality
according to print need and nozzle
channel condition.
E.g. At option of single-channel printing,
when there are damage in left channel
nozzle or there are missing dots in print
by left channel, user can switch to right
channel printing.
At option of dual-channel printing, left
channel and right channel will work at
same time for printing to achieve darker
print and best print quality.
9
Continuous
printing
Multiple outputs of same print during
one session of period photocell
sensing the print object.
10
Printing
Recovery
When there is a power failure, and
the setting is "ON", system will go
back to the last printing status and
resume printing when power gets
back. The default setting for this
function is "OFF"
When the printing contains counter,
and the Printing Recovery setting is
"ON", operator need to check on the
counter value and do needful
adjustment.