SOFTLINK WB169-430, Manual

Page: 8 / 32

List of all configuration commands (”HELP”) can be displayed by entering of ”?” command into the command
line and pressing of
”
ENTER” key. The following list of commands will display in the terminal window:
mon#?
Help :
--- System commands ---
deb : Show or set debug level
ta : Show tasks
mb : Show mail boxes
du addr : Dump memory
rb addr : Read byte from addr
rw addr : Read word from addr
rd addr : Read dword from addr
sb addr val : Set byte on addr
sw addr val : Set word on addr
sd addr val : Set dword on addr
port : Show port [a,b,..]
show : Show info
write : Write configuration to flash
cread : Read configuration from flash
clear : Clear configation and load defaults
--- WMBUS commands --- ---
mid : Show or set MBUS ID (0 - 99999999)
power : Show or set MBUS power (1 - 5)
manuf : Show or set MBUS manufacturer code (AAA)
info : Show or set MBUS info string (0-30 chars)
vers : Show or set MBUS version (0 - 255)
medium : Show or set MBUS medium (0 - 255)
periode : Change periode of send 0 - disable, >0 period in minutes
mode : Set WMBUS mode 1 - N1, 2 - N2
chan : Set WMBUS channel, type ? for help
ekey : Set encrypt key W-MBUS, point ’.’ no encrypt
skey : Set encrypt key Sensus
sid [index] [value] : Set Sensus meter ID
--- Modem commands ---
mr : Modem receive mode 0 - off, 1 - on 169MHz, 2 - on 433MHz
mt test time : Set test on modem, 1 - TX carrier, 2 - TX sync, time is in second, default 10
ms : Get modem state
mi : Get modem info
recvwin : Set receive window in sec.
radar : show radar table
--- Utils ---
tz : Time offset in hours
ppm : Set RTC ppm
time : Show or set rtc time, set as BCD : 0x102033 is 10:20:33
date : Show or set rtc date, set as BCD : 0x171231 is 2017-12-31
uptime : Show uptime
sens : Show sensors
mfreq : Set or get xtal frequency correction
sfreq : Set frequency correction from analyzer in Hz, example : 196431200
cfreq : Set +- frequency correction, 1 = 1Hz
sendp : Send nx WMBUS messages
send : Send WMBUS message
reset : Reset device
? : Show this help
mon#
Overview of configuration parameters with short description of their meaning can be also found in table 2 on the
page 17 . The meaning of individual parameters and detailed description of their usage can be found below.
WB169-430 5