TH LINK Industrial Ethernet - Installation Manual
8
Copyright 2017 Softing Industrial Automation GmbH
2.3
Mount device
Note
Make sure you have a minimum of 5 cm below and above the TH LINK in order to ensure
heat dissipation.
Figure 2: Mount and unmount the TH LINK
[1] Device with notch on DIN rail
[2] DIN rail
[3] Device on DIN rail
[4] Stop lever
1. Place the device with its notch on the DIN rail.
2. Move the device downwards until the stop lever locks into place on the DIN rail.
Unmount TH LINK:
1. Remove the connected supply and signal lines (Ethernet, power supply).
2. Place the screwdriver into the stop lever on the device (see figure above).
3. Press the screwdriver in the direction of the device and simultaneously swing the device off the DIN
rail.
Summary of Contents for TH LINK
Page 4: ......
