12
http://itnetworks.softing.com
CableMaster 400
Voice Mode
Voice Mode Data Mode
Tone Generation Mode
On/Off and ID Mode
LOCATION ID
The “ID” symbol, located in the third line of the LCD screen, appears when the
CableMaster is in Video, Data or ID Mode. When using the wire mapping remotes,
the “ID” icon will turn on and the remote ID number will display to its right. The ID
number is not displayed if an error occurs, such as “Open” or “Short”.
VOLTAGE DETECTED WARNING
If voltage is detected on any of the cable connectors, the “Voltage!” icon flashes. A
check for voltage is performed before each test and if found, no test is run. If the
icon appears, the tester should be disconnected immediately from the source of the
voltage. The tester automatically powers down in 90 seconds if the detected voltage is
not removed.
KEYPAD
The CableMaster is equipped with five buttons, illustrated in Figure 3. Some buttons
have more than one function. The functions are explained in Table 6. For each cable
test, results are displayed in the Wire Map of the LCD display screen.
Figure 3. Keypad
