7
LinkXpert Manual English
© 2022 Softing IT Networks
Safety instructions and cleaning
3
Safety instructions and cleaning
Safety instructions
To prevent fire, electric shock, injury or damage to the equipment:
1. Use the device only within the device specifications, See
2. Use only compatible chargers approved by Softing.
3. Never connect the device to live wiring of more than 60VAC or 60VDC or devices
with voltages greater than 60VAC or 60VDC.
4. Do not open the case. You cannot repair or replace any parts inside the enclosure.
5.
Opening the housing will void the warranty!
6. This device is not intended to be used in residential areas and cannot ensure
adequate protection of radio reception in such environments.
7. If you replace parts that are not specified as spare parts, the warranty for the
product is voided and the product can no longer be used safely!
8. Contact only service centers authorized by Softing. See
1. Red light source (
M3
)
Never look directly into the red light source with the naked eye, as this may cause
permanent, non-healable injuries to the eye.
2. SFP modules and fiber optic cables (
M3
)
Never look directly into SFP modules or at open fiber optic cables with the naked
eye, as you must always assume that light in the non-visible wavelength range can
escape. This light can cause permanent, non-healable injuries in the eye and in the
worst case can lead to permanent loss of eyesight.
The crossed-out trash can means that you are required by law to take this equipment
to a separate collection from unsorted municipal waste. Disposal via the residual
waste garbage can or the yellow garbage can is prohibited. If the products contain
batteries or rechargeable batteries that are not permanently installed, these must be
removed before disposal and disposed of separately as batteries.
Cleaning
1. Device cleaning:
Switch off the device before cleaning and disconnect it from the power supply if necessary.
Use only dry, lint-free and antistatic cloths to clean the device and the screen.
When cleaning the screen, avoid scratching the screen with cleaning cloths that are too rough or dirty.
2. Red light source, SFP modules and fiber optic test cable (
M3
):
When cleaning fiber optic connectors and fiber optic ferrules, use only Softing-approved dry cleaning
agents
10
52
Summary of Contents for LinkXpert
Page 1: ...LinkXpert Manual English 2022 Softing IT Networks Softing IT Networks Version 1 08 22 ...
Page 11: ...11 LinkXpert Manual English 2022 Softing IT Networks Introduction ...
Page 53: ...53 LinkXpert Manual English 2022 Softing IT Networks Service und Support ...
Page 54: ...54 LinkXpert Manual English 2022 Softing IT Networks Back Cover ...
