12
NETYS PR RACK 1U
- Ref.: IOMNETPRXX01-GB 02
7. MODES OF OPERATION
7.1. TURNING THE UPS ON
After the UPS is connected to a power outlet, the UPS enters Standby mode. To turn on the UPS, press and hold the
button until
you hear the UPS beep (approximately two seconds). After the UPS is turned on, it conducts a self-test and enters Normal mode.
The
, Load 1, and Load 2 indicators illuminate indicating that power is available from the UPS output receptacles.
Starting the UPS on Battery
NOTE
The UPS does not auto-detect the input frequency when starting on battery; the default is the last frequency used
by the UPS.
To turn on the UPS without using utility power, press and hold the
button for two seconds. The UPS supplies power to your
equipment and goes into Battery mode.
7.2. TURNING THE UPS OFF
To turn off the UPS, press and hold the
button for two seconds and then unplug the UPS from the power outlet. If you do not
unplug the UPS, it remains in Standby mode.
7.3. STANDBY
MODE
When the UPS is turned off and remains plugged into a power outlet, the UPS is in Standby mode. All indicators are off and power
is not available to your equipment. The battery recharges when necessary.
NOTE
For 200-240V models, the output receptacles may remain electrically live (up to 100-120V). Unplug the UPS to
ensure power is not available to the output receptacles.
7.4. INITIATING THE SELF-TEST
NOTE
The batteries must be fully charged and the UPS must not be in Battery mode to perform the self-test.
Press and hold the
button for three seconds to initiate the self-test. If the UPS finds a problem, an LED indicates where the
problem is. For more information, see "Troubleshooting" on page 47.
