11
5. INSTRUCTION OF OPERATION
5.1 Preparation for Operation
5.1.1 Adjustment of the Clamping Vise
(1) Release the handle.
(Cutting head shall be at up position)
(Saw blade motor shall stop.)
(2) Turn the vise hand wheel counter-clockwise to open the vise.
(3) Put a work piece into the clamping area of vises.
(4) Turn the vise hand wheel clockwise to close the vise and fasten a work piece.
(5) Turn the vise hand wheel 1/2 (half) turn counter-clockwise to open the vise slightly.
This is the ready position to take in or remove a work piece.
5.1.2 Installation of the Saw Blade
(1) Release the handle.
(2) Turn off the saw blade motor speed select switch.
(3) Open saw blade safety cover.
(4) Remove the clamping flange from the saw arbor.
(5) Clean the clamping surfaces of flange and arbor free from any dirt or chips.
(6) Clean the clamping area of the saw blade.
(7) Mount saw blade on the arbor. Align the pinholes of saw blade and arbor. Put the
clamping flange on the saw blade, and tighten the center bolt.
Note:
The rotation of saw blade shall be
counter-clockwise
while looking at the
mounting surface. There is a directional mark labeled on the protection cover.
(8) When lock the center bolt,
keep the front part of saw blade downward
to eliminate
the gap between pin and pinhole.
(9) Close the saw blade safety cover.
Note:
The following Charts of " Number of Saw Blade Tooth Selection " are for reference.
Number of Saw Blade Tooth (
T
) for Mild Steel Solid Bar Cutting
Diameter of Saw Blade ( mm )
Wall
Thickness of
Tube ( mm )
Φ
250
Φ
275
Φ
300
Φ
350 Remark
0.6
～
0.8
T
=280 280 300 320
For
Tube
Summary of Contents for MC-275F
Page 5: ...5 2 4 Outline Description 1 Front View...
Page 6: ...6 2 Right Side View...
Page 7: ...7 3 Left Side View...
