Do not insert the card backwards.
Do not push the card in too hard, or you can damage the card or the card slot of
your PDA.
Note: To remove the SD Scan Card, push the card completely into the slot. After the card
springs back, you can safely remove the card. Do not pull the card out without pushing
first, or you can damage the connector the next time you insert a card.
2.
Make sure the
SocketScan
icon changes to indicate that the SD Scan Card is detected.
STEP
6:
O
PEN
Y
OUR
A
PPLICATION
Open the application that you want SocketScan to feed scanned data into (e.g.,
Excel, Notepad, etc.). Place the cursor where you would like data from the next scan
to go.
STEP
7:
S
CAN
D
ATA INTO
Y
OUR
A
PPLICATION
1.
Press the assigned trigger button and scan the barcode. Make sure the aiming
beam covers the entire width of the barcode.
When data is read, a beep will sound, and the scanner beam will turn off. If the
SD Scan Card fails to read data within a few seconds, the scanner beam will turn
off, and you must try again.
Note: For tips on scanning technique, please refer to Appendix E.
Note: If your device enters sleep mode when SocketScan is running, press the ON
button to initialize the scanner and resume operation.
2.
After a successful scan, data should appear in your document. By default, the
cursor will automatically advance to the next line, ready for the next scan.
Note: For information on the application features of SocketScan, please refer to
Chapter 3.
26