Soaring USA Stobel V2, Instructions Manual

Page: 8 / 8



This leave only the canopy cover to complete. Sand the inside a bit and then glue in the supplied Carbon rod.
Allow 10-15mm on both ends of the cover. As a tip: Vary the lengths of the overlap, then you can immediately
distinguish the front and rear.
Suggested Settings for flying
Suggested cg 64-66mm
Ailerons, elevator & rudder
Up down
Rudder max. max.
Elevator 4mm 4mm
Flaps 15mm 15mm
Flight mode settings
Flap Elevator
Landing max.down aprox 25% down
Launch 3mm up normal / if need 2-5% up
elevator/flap – mix 1° elevator down = 1° Flap up
Flap for thermal mode (ballast taken into consideration)
For crashes and any resulting damage to one of our models, we can not Assume responsibility or liability as
a proper setup and operation is not
can be monitored.

For the antenna use a 25cm long piece of 0.3
mm steel wire. This can be glued well insulated
at the end of the rudder . The connection to the
receiver can be by solder or connector of choice.

260g 3,5mm down
280g 4mm down
310g 4,5mm down