Now you need to install the 4-pin connector for the wing to fuz wiring harness. Using the 4 pin connector
provided, complete the wiring harness allowing enough length to reach the connecting harness from your
receiver.
Completion of the Elevator and Rudder
The tail feathers of Stobel V2 are a high quality prefabrication. The springs provided (see diagram below) are
designed to optimize precise control of the tail feathers via the supplied control horns. This type of linkage has
been 100% proven and should be installed as illustrated and described.
Turn the corresponding feathers from the attached wire.
For the vertical stabilizer use the thin 0.3 mm provided,
and for the horizontal stabilizer use the 0.5 mm spring
provided.
The small tube pieces should be in inserted into the tails
per the diagram on the next page and be glued in. These
absorb the force and prevent friction of the steel wire at
the Tail surface
Summary of Contents for Stobel V2
Page 1: ......
