![SNR SNR-VP-6020 User Manual Download Page 29](http://html1.mh-extra.com/html/snr/snr-vp-6020/snr-vp-6020_user-manual_1310632029.webp)
Enable Via rport
Signal Encrypt
If some server refuse to register with too short interval time, and
has no packets sending to device in private network to keep NAT
alive, user could set this function ON. It need set the keep alive
interval time less than the NAT server’s.
Enable/Disable system to support RFC3581. Via rport is special
way to realize SIP NAT.
Enable/Disable Signal Encrypt.
Enable Private Register Enable/Disable Private Server Register.
Rtp Encrypt
Enable/Disable Rtp Encrypt.
Enable Session Timer
Set Enable/Disable Session Timer, whether support RFC4028.
Enable Subscribe
Answer With Single
Codec
Enable/Disable sending SUBSCRIBE messages to subscribe other
phones’ status or voice mail after being registered.
Enable/Disable the function when call is incoming, phone replies
SIP message with just one codec which phone supports.
Enable URI Convert
Enable/Disable the function when phone sends SIP request, using
%23 instead of “#” character in SIP URI.
Notice: SIP STUN is used to realize SIP penetration to NAT. If your phone configures STUN
Server IP and Port (default is 3478), and enable SIP Stun, you can use the ordinary SIP Server
to realize penetration to NAT.
4.2.4.7. Digital Map Configuration
This system supports 4 dial modes:
1). End with “#”: dial your desired number, and then press #.
2). Fixed Length: the phone will intersect the number according to your specified length.
3). Time Out: After you stop dialing and waiting time out, system will send the number collected.
4). User defined: you can customize digital map rules to make dialing more flexible. It is realized by
defining the prefix of phone number and number length of dialing.
Digital Map Configuration
End with "#"
Fixed Length
Time out
Set Enable/Disable the phone ended with “#” dial.
Specify the Fixed Length of phone ending with .
Set the timeout of the last dial digit. The call will be sent after
timeout.
Below is user-defined digital map rule:
[] Specifies a range that will match digit. May be a range, a list of ranges separated by commas,
or a list of digits.
29
Summary of Contents for SNR-VP-6020
Page 1: ...SNR VP 6020 User Manual...