10
m
WARNING!
Keep hose away from sharp objects.
Bursting hoses may cause injury. Examine hoses regularly and
replace if damaged. Do not attempt to mend a damaged hose.
9.
Connect the garden hose adapter (female coupler) to
the water inlet of the pressure washer, then thread your
garden hose (male end) into the garden hose adapter
(Fig. 9). The garden hose must have an internal diameter
of at least 13 mm (1/2 in.) and must be reinforced. The
water supply must be at least equal to the washer delivery
capacity.
NOTE:
The machine is not suitable for connection to the
potable water main.
10.
Attach garden hose to water supply (Fig. 10).
m
WARNING!
The intake water temperature must
not exceed 104
º
F/40
º
C. The water supply must not
exceed 0.7 MPa.
m
CAUTION!
The washer must only be used with clean
water; use of unfiltered water containing corrosive chemicals
will damage the washer.
11.
Make sure the motor switch is pushed to the OFF (0)
position before plugging the unit into the power outlet
(Fig. 11).
12.
Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specified on the pressure
washer rating plate. If the power supply is correct, you
may now plug the pressure washer into the power outlet
(Fig. 12).
NOTE:
The GFCI may need to be reset when first plugged
into the electric outlet. Press the "Reset" button until the
power light indicator on the GFCI illuminates.
Fig. 9
(FRONT)
Water inlet
(female
coupler)
Garden hose
Garden hose
(male end)
This end to
water inlet
Fig. 10
Connect to water supply
Garden hose
OFF/0
ON/l
Fig. 11
RESET
TEST
Fig. 12
GFCI
Power light
indicator
Reset
