11
5. Screw the big and small pulley plates back into position,
then reinstall the tensioner.
6. Place the left side cover back into position and refasten
the seven (7) screws.
Replacing the Scraper Blade
m
WARNING!
Disconnect the power from the electric
snow shovel before performing this task.
1. Position the auger so that you can gain access to the
three (3) Phillips head screws that secure the scraper
blade to the base of the unit.
2. Using a long Phillips head screwdriver, remove the
three (3) screws and the old scraper blade (Fig. 17).
3. Install the new scraper blade and fasten it securely to the
snow shovel with the three (3) screws.
Lubricating the Electric Snow Shovel
This electric snow shovel does NOT need lubrication. All
bearings are lubricated at the factory for the life of the product.
Storage
1. Examine the electric snow shovel thoroughly for worn,
loose or damaged parts. Should you need to repair or
replace a part, contact an authorized Snow Joe
®
+
Sun Joe
®
dealer or call the Snow Joe
®
+ Sun Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563) for assistance.
2. Examine the extension cord thoroughly for signs of excess
wear or damage. If it is worn or damaged, replace it
immediately.
3. Disconnect the extension cord from the electric snow
shovel before storing.
4. Store the cord with the electric snow shovel indoors in a
clean, dry and locked location out of the reach of children
and animals.
NOTE:
Devices for retaining extension cords are
commercially available, should you wish to purchase one.
5. For added protection against snow, ice, sun damage, rain,
dust, tree sap and birds, cover your electric snow shovel
with the Snow Joe
®
Universal Fit Snow Shovel Cover
(Model SJPCVR). To order this cover online, visit
snowjoe.com or, to order by phone, call 1-866-SNOWJOE
(1-866-766-9563).
S Support
If your Snow Joe
®
324E-RM electric snow shovel requires
service or maintenance, please call the Snow Joe
®
+ Sun Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563).
Model + Serial Numbers
When contacting the company, reordering parts or arranging
service from an authorized dealer, you will need to provide the
model and serial numbers, which can be found on the decal
located on the housing of the unit. Copy these numbers into
the space provided below.
Fig. 16
Belt
Tensioner
Small pulley plate
Big pulley plate
Fig. 17
Scraper
blade
3 screws
Use a long
Phillips screwdriver
Please record the following numbers from the housing or handle of
your new product:
Model #:
Serial #:
3 2 4 E - R M
