Lit. No. 72107, Rev. 02
16
November 15, 2018
Press the Start/Stop button. The auger and spinner
will begin to turn, spreading material.
Use the dials on the control pendant to adjust the
material distribution shaft speed. This will change the
spread rate at constant vehicle speed.
Press the Start/Stop button to stop spreading.
Turn OFF the spreader by pushing the ON/OFF button.
SPREADING TIPS
• Spread ice melters with the storm to prevent
unmanageable levels of ice.
• Never exceed 10 miles per hour when spreading.
• Calculate spread pattern when near vegetation
and other vehicles.
• Never operate spreader near pedestrians.
For a heavier pass:
• Decrease vehicle speed.
• Increase auger speed.
For a lighter pass:
• Increase vehicle speed.
• Decrease auger speed.
For a wider pass:
• Increase spinner speed.
OPERATING THE SPREADER
OPERATING THE SPREADER –
CAB CONTROL
Using the Control Pendant
To start the spreader, press the ON button on the control.
Press the OFF button to stop the spreader.
NOTE: The truck ignition must be ON to start the
spreader.
NOTE: If truck ignition is turned OFF while
spreader is running, the motors will stop.
WARNING
Never operate equipment when under the
in
fl
uence of alcohol, drugs, or medications
that might alter your judgment and/or reaction
time.
WARNING
Never allow children to operate or climb on
equipment.
WARNING
Never exceed 45 mph (72 km/h) when loaded
spreader is attached to vehicle. Braking
distances may be increased and handling
characteristics may be impaired at speeds
above 45 mph (72 km/h).
WARNING
Before starting the spreader, the driver shall
verify that all bystanders are a minimum of
25 feet away from operating spreader.