Lit. No. 70440, Rev. 00
16
April 1, 2016
OPERATING THE SPREADER – CAB CONTROL
Setup Codes
Code
De
fi
nition
Procedure
Cb
Calibrate the Empty Hopper setting.
With control in ON mode, press and hold the left control knob until the
Cb
code displays. Calibration cycle is automatic.*
Cc
Clear calibration data for Empty Hopper
setting; clear EH code.
Press the right control knob to clear all calibration data during the
calibration cycle.
LS
Set LED brightness level.
With control in Ready mode, press and hold left control knob to get
LS
code. Release pressure and turn left control knob to desired
brightness setting. Wait for con
fi
rming
SL
code to display.*
SL
Con
fi
rms that LED brightness level has
been reset.
*
For full instructions, see the "Setup Procedures" section.
Information Codes
Code
De
fi
nition
Response
Ar
Auto-reverse sequence is active.
The spreader will automatically detect and attempt to clear a jam. See
the "Operating the Spreader" section of this manual.
dU
Not applicable to tailgate spreaders.
Possibly indicates a harness or
module issue.
Contact authorized dealer.
EH
Empty hopper (beep will sound).
Check hopper for material.
Recalibrate Empty Hopper setting as described above for
Cb
code.
Lb
Low battery. Hopper module is sensing
< 10V. (
Lb
becomes an error code
when module senses < 6V.)
Refer to the
Lb
row under "Error Codes" (next page).
CAB CONTROL CODES
Table continues on next page.
Error Codes – Spreader Operation Stopped
Code De
fi
nition
Possible Cause
Suggested Solution
bb
Bad button
Button is stuck.
Button was pressed while
vehicle ignition was entering
ACC or START mode.
Possible harness issue.
Inspect control. Free up button.
Do not press any spreader cab control buttons
while the vehicle ignition is being engaged.
Check connections and integrity of vehicle
harness.
bH
Bad hopper
Possible module or control
mismatch.
Replace control or module. Use only genuine
service parts. Contact authorized dealer.
CE
No communication with
spreader module
Loose connection.
Module lost power.
Con
fi
rm that spreader and control harnesses are
connected to the vehicle harness. Check fuses,
power to spreader module, all connections and
power studs. Check that B port is plugged into
the module.
CF
Control malfunction
Control is overheating.
May be a combination of faults.
Inspect connections at spreader module, hopper
drive motor and spinner drive motor.
