9
16 Reverse gearbox*
*For models with Reverse gearbox.
To shift the gear into the «forward» position, stop the engine
and switch the lever towards the transmission chain as shown
on the picture.
To shift the gear into the “reverse” position, stop the engine
and switch the lever away from the transmission chain as
shown on the picture.
!
WARNING!
Never switch the direction of motion
with the running engine!
17 Maintenance tips
17.1 Changing the oil
Change the oil in the engine produce in accordance
recommendations to the operator`s manual engine.
!
CAUTION
!
Do not touch the muffler immediately
after the engine is stopped in order to
avoid getting burned.
17.2 Replacement CVT belt
1. Turn off the engine,
2. lock the parking brake.
To replace the CVT belt, pull the belt off the large pulley and
then from the CVT (as per picture below). Install the belt in the
reverse order.
Replace the CVT belt, if it`s worn out or its width is less than
1,06 in (27mm).
17.3 Track tension check
Before starting any movement check the condition and tension
of the track. Over tension leads to engine power loss and
causes overloads. Place the SNOWDOG on a flat surface. Place
a rigid metal of wooden «straight edge» on top of the track
supported by the front and back rollers. Measure the distance
between the «straight edge» and the track in the the middle of
its length. Normally the track will sag on 0.6-0.8 in (15-2mm)
(in the middle of its length) under its own weight.
Summary of Contents for COMPACT B10ZE WL
Page 15: ...15...
