Put the bottom of Sub-Pole
inside for the length of
your foot (about 27 cm)
Front view of the Shelter Side Wall
Triangular Panel
Entrance Panel
Rubber Loop (10 Locations)
Insert the duralumin pin pegs into the loop at each corner of the shelter's bottom and the rubber loop at
the bottom of the front and rear panels, then hammer down (10 locations total). Peg down so the bottom
of the sub-pole is inside by the length of a foot (about 27 cm), and the sidewall is inclined.
* For the front and rear panels, please peg down the rubber loop attached to both the entrance panel and
the triangular panel.
8
Following the figure below, adjust the stopper's position on the rope and apply tension. Pull each rope
equally, and tighten the ridgeline by pulling the forked end ropes (after applying the tension of ropes
⑦⑧
⑨⑩
). Then, pull all the ropes again in the order of the numbers shown in the figure.
9
9
①
②
③
⑥
⑦
⑧
⑨
⑩
④
⑤
Top view