Snow Peak Living Lodge L, Manual, Page: 8 / 16

Enter the shelter and insert the main pole (middle) into the center grommet to raise the structure. Adjust
the position of the bottom pole so that each main pole stands up straight.
5
Insert the lower end of the sub-pole into the pin at each corner (6 spots total) of the bottom, then insert the
tip into the grommet at the roof corner. Then, find the shelter's Velcro tape (located near the middle part
of the sub-pole), wrap the Velcro tape around the sub-pole, and attach it to the body.
6
As shown in the figure "Location of Rope with Rope Tensioner and Pegs" on P4, attach the rope with a
stopper at each corner to the shelter, then tighten and secure with the peg, then apply tension. * If the
rope is pulled too much, the fabric will be burdened and potentially damaged. Please be careful not to pull
too much.
* Please use a peg with a length of 25 cm (9.8') or more for the peg down.
7
8
Tip of the
Sub-Pole
6 Places
Pin
Lower
End of the
Sub-Pole
Bottom
Part
Roof Corner
Grommet
Tip of the Main Pole (middle)
Push Pin
Velcro Tape
Sub-Pole
B
B
B
B
A
A
A
A
B
Sub-Pole Division C
B
6 Places
C
A
A