Snow Peak GigaPower WG STOVE, Instruction Manual, Page: 12 / 23

12
4. Turn the Light/cook lever clockwise to the LIGHT
position.
5. Place thumb over hole in center of the pump knob and
slowly pressurize canister by pumping approximately 50 times.
Caution: Pump gently without excessive force. Forceful pumping may result in damage to
the pump shaft.
Caution: If the fuel level in the bottle is low, the pressure inside the fuel canister may not be
optimized. In this event, pump an additional 20-30 times or refill the bottle to the Fill Level
Line.
6. Carefully unfold the Pot support of the stove until it “clicks”
into the locked position.
Caution: Confirm that all Pot supports are securely locked into position prior to use.
7. Remove the protective cap from both ends of the fuel hose.
Carefully join the connector with the generator on the
stove by turning the connector clockwise .
Caution: Either end of the fuel hose may be used. Firmly tighten the connector by
hand; DO NOT use any tools to tighten.If a tool is used to tighten, the threads may be
damaged while in use. Keep the protective cap free from dirt and dust.
Caution: If the stove is lighted in the COOK position
(counterclockwise ) , excessive fuel will be
injected into the unit resulting in an unstable flame. If
the condition is not corrected, fuel may leak around
the damper tube and spontaneously ignite. The lever
must be in the LIGHT position when lighting the
stove.