Installing Snooper using the Dash Mounting Disk
If you prefer not to attach your navigation device to the windscreen, Snooper provides a dashboard mounting disc t
o fix y
our
Snooper suction cup mount to your dashboard instead.
Instructions:
●
Clean the area where you want to install the disc on the vehicle’s dashboard with a damp cloth, then dry the dashboard.
●
Peel the paper backing away from the permanent mounting adhesive located on the disc bottom.
●
Press the disk onto the dashboard in the desired location, then set the GPS suction cup mount on top of the disk. Twist the suction
cup mount’s lever. This locks the Snooper in to place.
Note: Take care when attaching the disc. This type of bracket is not intended to be moved from vehicle to vehicle and is classed
as a permanent fixing.
THE USE OF THE DASH MOUNT DISC IS NOT RECOMMENDED FOR LEATHER DASHBOARDS.
Power Connection & Charging
Powering and charging Snooper from the cigarette lighter socket
Snooper comes with a power cable designed to plug into your vehicles cigarette lighter socket. The power cable is suitable for
both 12v DC and 24v DC vehicles. This lead will power the device but will also charge Snooper’s internal battery (when the device is
switched OFF).
1. Plug the power cable into the unit or on the S6900 into the active mount.
2. Plug the other end of the cigarette lighter adaptor into your vehicles cigarette
lighter socket.
3. Press and hold the standby power switch on the top of Snooper for two seconds
to switch the device ON (Note: The device will power up automatically if there is
power being supplied by the vehicle power cable).
If Snooper does not power up please check that the cigarette lighter socket is clean of
any debris, remembering not to insert metal objects into the socket. Check that the
cigarette lighter adaptor is inserted all the way into the socket and check that the fuse
in the cigarette lighter adaptor is operational. If Snooper will still not power up, please
check that the cigarette lighter socket in your vehicle is functioning correctly.
Pictures are for illustrative purposes only.
Micro SD cards
SC5800 and SC5900 only
The mapping and DVR/DashCam Micro SD cards must not be
swapped around.
If the SW/Mapping MicroSD card is placed in the DVR, by
mistake, the Micro SD card will be
formatted
automatically and
ALL mapping data will be lost.
All Units
Under
no circumstance
should the mapping MicroSD card be
formatted when the unit is connected to a PC.
Sometimes during an mapping or speed camera update the
Windows operating system will advise the "the SD card requires
formatting" please click CANCEL.
If the card is formatted then all mapping data will be lost and
the unit will be
unusable ,
until the card is replaced - current
replacement card cost is £9.99*
*
Cost is subject to change
SC5800/SC5900
Pictures are for illustrative purposes only.
3 of 10
QSG EN v1.1 11/19
