11
To install the base station:
1. Plug one end of the Ethernet cable into the Ethernet port on the rear of the base
station (marked by
), and plug the other end of the cable into your network
router or switch.
2.
If the base station is not using power from a PoE-capable network router or switch:
a. Connect the supplied power adapter to the base station power jack.
b. Plug the power adapter into an electrical outlet that is not controlled by a wall
switch.
Use only
Supplied
Adapter
RESET
IMPORTANT INFORMATION
1. Use only the power adapter supplied with the product. To order a replacement
power adapter, visit our website at
www.snomamericas.com
.
2.
The power adapter is intended to be correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold the plug in place if it is plugged into
a ceiling, under-the-table or cabinet outlet.
To mount the base station on a wall:
1. Install two mounting screws on the wall. Choose screws with heads larger
than 5 mm (3/16 inch) in diameter (1 cm / 3/8 inch diameter maximum).
The screw centers should be 5 cm (1 15/16 inches) apart vertically
or horizontally.
2. Tighten screws until only 3 mm (1/8 inch) of the screws
are exposed.