22
Pivot Assembly Pivot Screws
Figure 2-6
1. The hex head of the pivot screw must be seated
within the hex opening of the retainer plate.
Figure 2-7
2. Install the special 1/4" thick washer on the threaded
end of the pivot screw and install the 1" slotted nut finger
tight. Then tighten the nut an additional 2/3 to 1 full turn
and line up a slot in the nut with the cross hole in the pivot
screw. Install a 3/16"x2" cotter pin through the slot in the
slotted nut and the cross hole in the pivot screw and
spread both cotter pin ends.
Cutting Edge
NOTE: Cutting edge must be replaced when it is worn to
the bottom edge of the frame.
1. Raise the plow to the full UP position.
2. Place suitable blocking under A-frame of plow to
allow at least 6" of clearance from the blade to the
ground.
IMPORTANT:
Make sure to position blocking away
from cutting edge so that when plow is lowered onto
blocking cutting edges do not rest on blocking.
3. Lower plow onto blocking.
4. Remove mounting bolts holding old center cutting
edge. Discard old cutting edges and hardware.
Figure 2-8
PIVOT SCREW
RETAINER PLATE
PIVOT SCREW
THICK WASHER
SLOTTED NUT
WARNING
Keep hands and feet clear of wings and A-frame
when setting blocking and lowering blade.
Moving or falling assemblies could result in
serious injury.
FAILURE TO HEED CAN RESULT IN SERIOUS
INJURY OR DEATH.
CAUTION
Cutting edges may be sharp. Always wear gloves
and handle cutting edges with care to avoid
injury.
CENTER CUTTING EDGE
MOUNTING STRIP
Summary of Contents for HTV200000
Page 26: ...25 HYDRAULIC SCHEMATIC GRAVITY...
Page 27: ...26 HYDRAULIC SCHEMATIC DOWN PRESSURE...
Page 28: ...27 WIRING SCHEMATIC GRAVITY...