Sno-Way HTV200000, Owner'S Manual, Page: 15 / 30

14
Fluid leaking at Pump
Assembly
Hydraulic fittings not torqued
properly (too tight, too loose)
Refer to Dealer
O-Rings between valve block and
endhead are cut or not seating
properly
Refer to Dealer
O-Rings between endhead and
reservoir cut or not seating
properly
Refer to Dealer
Reservoir over-full See Maintenance Section
O-Ring on solenoids or pressure
switches defective
Refer to Dealer
Endhead cracked Refer to Dealer
Valve body cracked Refer to Dealer
Unit lifts but does not hold -
first action
Dirt in check valve or Float/DP
solenoid valve
Cycle raise and lower system to
flush debris
Float/DP solenoid valve sticking Cycle raise and lower system to un-
stick valve
Unit lifts but does not hold -
second action
Dirt or debris in check valve Refer to Dealer
Check valve spring broken Refer to Dealer
Float/DP solenoid valve sticking Refer to Dealer
Seals O-Ring(s) on Float/DP
solenoid valve damaged
Refer to Dealer
Raise/lower ram defective Refer to Dealer
Machine failure Refer to Dealer
Unit will not lower
NOTE: Only in Non- down
pressure mode
Plugged breather cap See Maintenance Section
Low or no current available at
Float/DP Solenoid
Refer to Dealer
Float/DP solenoid valve sticking Refer to Dealer
Float/DP solenoid coil defective Refer to Dealer
Raise lower ram defective
allowing movement in one
direction only
Refer to Dealer
Machine failure Refer to Dealer
TROUBLESHOOTING
PROBLEM PROBABLE CAUSE CORRECTIVE ACTION