Sno-Tek 24E, Service Manual

Page: 25 / 44

EN – 23
See Figure 45.
8. Tighten bearing plate hardware.
9. Apply a thin layer of anti-seize to impeller shaft end.
10. Reinstall attachment drive pulley onto impeller shaft
and secure with locking washer and hex bolt. Torque
to 8 N•m – 16.5 N•m (5.8 lb-ft – 12.2 lb-ft).
11. Reinstall housing to frame. See Reinstall Auger
Housing on page 9.
12. Reconnect spark plug wire.
IMPELLER REPLACEMENT
Remove Impeller
IMPORTANT: Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Remove auger housing. See Separate Housing from
Frame on page 7.
See Figure 46.
4. Remove hardware retaining attachment drive pulley to
impeller shaft and remove pulley.
5. Loosen, but DO NOT remove bearing plate hardware.
6. Remove hardware securing auger support bushings to
auger housing. See Figure 39.
7. Remove auger assembly from housing. See
Figure 40.
See Figure 47.
8. Remove roll pins retaining impeller and remove
impeller.
IMPORTANT: Use of penetrating oil or heat may be
necessary to remove impeller.
Figure 45
Figure 46
1. Bearing Plate
2. Attachment Drive Pulley
1
2