HD2200
SECTION 4
HD22 14/03/01 Version 1 Issue 2
4.20
SETUP (Config)
Provides additional machine setup items.
ROLLCALL
Allows the unit name and logging information to be
set. The current RollCall address (in Hex) is
displayed when RollCall is selected.
Note that this address must be set using switches
on the main board (see Section 3, under RollCall)
and this menu can only display the address, not
change it.
SYSTEM NAME
Sets the RollCall unit name. The default is
‘HD2200’. The character selected for editing will
be highlighted.
To edit a different character press either the upper
left-hand button
adjacent to ‘<<<’ or the upper
right-hand button
adjacent to ‘>>>’. Once the
character is selected turning the front panel knob
changes the character.
Pressing the middle left-hand button
adjacent
to ‘Insert’ adds a space character to the name at
the highlight position. Pressing the middle right-
hand button
adjacent to ‘Delete’ removes a
character from the name at the highlight position.
Pressing the bottom left-hand button
adjacent
to ‘Undo’ returns the name to its value when the
Sys Name menu was last entered. Pressing the
bottom right-hand button
adjacent to ‘Accept’
makes the changes active.
LOG NAME
I
f the HD2200 is attached to a RollCall
=
network
with a logging device, information about various
parameters can be made available to the logging
device.
If the Log Name is blank (obtained by pressing the
PRESET button) and the cursor is at the left (no
spaces), logging information is available to all
logging devices on the RollCall network. If Log
Name is set to the name of a particular logging
device, only that device will receive information.
The log name can be edited as described in the
Sys Name section above.
LOG ITEMS
Selecting this item reveals a display that allows
information about five parameters to be made
available for logging.
The Log Items are:
Input
Status
When activated, a loss of
input signal condition will be
indicated to the logging
device.
Input Standard
When activated, the current
input standard will be
available to the logging
device.
Reference
Status
When activated, a loss of
reference signal condition will
be indicated to the logging
device.
Output Standard
When activated, the current
output standard will be
available to the logging
device.
Picture
When activated, the current
state of the output picture (i.e.
pattern, normal, frozen) will be
available for the logging
device.
HD2200
H
HH
H
