Snapper R1962519B, Safety Instructions & Operator'S Manual

Page: 7 / 24

7
Section 2 - OPERATING INSTRUCTIONS
2.1 PRE-START CHECK LIST
Make the following checks and perform the service
required before each start-up.
2.1.1. Check guards, deflectors, grass bag, adapter
and covers to make sure all are in place and securely
tightened.
2.1.2. Check blade control to insure it works freely.
See Figure 2.1.
FIGURE 2.1
2.1.3. Check cutting height. Adjust to desired height.
2.1.4. Check engine oil and add oil as needed to
bring level up to the full mark. Refer to Engine Owner’s
Manual for oil specifications. See Figure 2.2.
FIGURE 2.2
2.1.5. Add fuel to tank after pushing the mower
outside where fumes can safely dissipate. Fill tank to
1-1/2” below top of filler neck (to allow for fuel
expansion). Make sure cap is tightened after fueling.
Refer to Engine Owners Manual for fuel
specifications.
2.1.6. Clean exterior surfaces of cutting deck and
engine of any accumulation of spilled fuel, dirt,
grass, oil, etc. Keep engine air intake screen and
cooling fins clear at all times.
2.2 STARTING & OPERATION
2.2.1. ENGINE & BLADE
The engine speed is pre-set for optimum mowing
performance and is not adjustable. An engine primer
is provided to assist when starting a cold engine. The
primer should not be required when restarting a hot
engine.
1. Push primer bulb three times to start a cold
engine. NOTE: Primer should not be required when
restarting a hot engine. See Figure 2.3.
IMPORTANT: Stop the engine (and blade) by releasing
the blade control.
FIGURE 2.3
2. Pull blade control against handle.
3. Pull rope start handle to crank engine.
4. After engine starts, allow a brief warm-up until
engine runs smooth.
BLADE CONTROL
CHECK ENGINE OIL
PUSH PRIMER BULB
THREE TIMES