www.snapper.com
22
Maintenance
Rear Engine Rider Drive
Components
Your Snapper rider is equipped with a patented smooth start
clutch. The clutch should operate smoothly and provide
ample traction. If problems are experienced, contact your
Snapper dealer for repair.
Service Brake / Park Brake Adjustment
Test the wheel brake on a dry concrete surface. When prop-
erly adjusted, the Rear Engine Rider will stop within 5 feet
from fastest speed. If stopping distance is more than 5 feet,
the wheel brake should be adjusted as follows:
1. Follow the WARNING statement found on this page.
2. Check the fuel level in tank. If over 3/4 full, remove tank.
Refer to the section entitled “REMOVING THE FUEL
TANK”. If 3/4 or less, proceed to the next step.
3. Carefully stand the Rear Engine Rider on its rear
bumper.
4. Depress the clutch/brake pedal
(A, Figure 39)
all the
way down. Move and hold the park brake lever
(B)
in
the “ON” position and release the clutch/brake pedal to
set the park brake.
5. Measure the distance
(A, Figure 40)
between the end of
the clutch/brake cable
(B)
and the bottom of the housing
(C)
. The measurement should be 3/4”.
NOTE: The cotter pin, brake spring, and clutch yoke
(D, E,
and F, Figure 40)
are noted for reference purposes only.
6. If the measurement is not 3/4”, loosen the two jam-nuts
(A, Figure 41)
. Hold the clutch/brake cable
(B)
to the
chain case bracket.
7. Adjust the cable up or down using the jam-nuts to
obtain a distance of 3/4” between the end of the
clutch/brake cable (adjustment shown in inset of Figure
40) and the bottom of the housing.
8. After adjustment is complete, securely tighten the cable
jam-nuts.
9. Retest the wheel brake.
Maintenance (Continued)
WARNING
DO NOT attempt any adjustments, maintenance, service or
repairs with the engine running. STOP engine. STOP blade.
Engage parking brake. Remove key. Remove spark plug
wire from spark plug and secure away from plug. Engine
and components are HOT. Avoid serious burns, allow all
parts to cool before working on machine. Fuel Filler Cap
and vent must be closed securely to prevent fuel spillage.
!
!
Figure 40: Adjusting the brake cable
Figure 41: Brake cable adjusting nuts
A
Figure 39: Setting the park brake
A
B
B
C
C
A
D
E
D
B
E
Summary of Contents for 2811523BV (7084940)
