Snapper 1696219-00, Operator'S Manual

Page: 15 / 116

15
en
Operation
Stop the Engine
WARNING
Š J [#
and explosive. Fire or explosion can cause
severe burns or death. DO NOT choke the
carburetor to stop the engine.
Before stopping the engine, allow it to idle for a few minutes
to help dry off any moisture.
1. Turn the ON/OFF or Push/Pull key ( A , Figure 7) to the
OFF position and remove or pullout the Push/Pull key if
equipped.
2. Keep the ON/OFF or Push/Pull key out of the reach of
children. The engine cannot be started without the ON/
OFF or Push/Pull key.
Operate the Snowthrower
WARNING
Before operating, make sure the area in front
of the snowthrower is clear of bystanders or
obstacles.
DO NOT discharge snow toward a building as hidden
objects could be thrown with sufficient force to cause
damage.
1. Start the engine. See Start the Engine in this section.
2. Adjust the direction and angle of the discharge chute
( A , Figure 8). See Discharge Chute and Deflector in
this section
3. Fully press and hold the auger control ( B ) to engage
the auger rotation. Releasing the auger control lever will
disengage the auger.
4. Push the unit into the snow.
NOTE : When clearing wet, heavy, snow, reduced your
speed, maintain full throttle, and clear less than the full
width of the unit.
5. Tip the handle bars ( C ) forward slightly. This will cause
the snowthrower to pull itself forward.
WARNING
Read Operator’s Manual before operating machine. This ma-
chine can be dangerous if used carelessly.
* ; ;
and shields in place.
* #
near machine while engine is running.
> #
housing or the discharge chute and before making repairs or
adjustments.
= ; "
the risk of fire, keep the machine clean and free from spilled
gas, oil, and debris.
; ; ;
moving parts on engine and snowthrower.
" # J ‰‘‹’Q
(66°C). Avoid these areas.
> *" #
while it is operating.
DANGER
Z # J; -
less, colorless, poison gas. Breathing carbon
monoxide can cause nausea, fainting, or
death.
> ;
windows are open.
Stop the Snowthrower
1. Release the auger control ( A , Figure 9).
2. Turn the ON/OFF switch ( B ) to the OFF position and
remove or pull out PUSH/PULL key.
Not
for
Reproduction