202
Maintenance
M2 Scope/Meter
:$51 ,1*
Risk of electric shock.
• Prior to recycling the battery pack, protect exposed terminals with heavy insulating tape
to prevent shorting.
• Disconnect all test leads and turn diagnostic tools off before removing the battery pack.
• Do not attempt to disassemble the battery or remove any component projecting from or
protecting the battery terminals.
• Do not expose the Diagnostic Tool or battery pack to rain, snow, or wet conditions.
• Do not short circuit the battery terminals.
Electric shock can cause injury.
IMPORTANT:
Be aware of all applicable safety considerations when replacing, handling, and recycling batteries.
Refer to
"Battery Safety Guidelines‚" on page 197
for details.
z
To replace the battery pack:
1. Refer to
:
1— Hanger Catch
2— Captive Screw
Figure 17-8
M2 Scope/Meter battery pack replacement
2. Press to release the hanger catch on the back of the M2 Scope/Meter (
), then
swing the hanger up (180º) so that it is fully extended.
3. Loosen the captive screw that secures the battery cover (
).
4. Remove the battery cover.
5. Remove the battery pack from the M2 Scope/Meter housing to access the electrical
connector.