8 of 18
5.4 ANCHORING PROCEDURE
NOTE:
The lift must always be anchored to a level and smooth floor. If the lift is to be
operated in different locations, a portable kit, that includes a tow cart and outrigger, must
be used. A portable kit (EELR319APKT) can be purchased from your SNAP-ON dealer.
Note:
When the tow cart is used, the lift must be in the fully down position and
vehicles must be removed from the lift
.
1. Position the lift in the center of the work area or bay to ensure adequate clearance
around the lift. To move the lift, raise the rear end off the ground and roll it into
position. Place the power pack stand in a suitable area.
2. Raise the lift to its full height and lower it onto its safety.
3. Using a rotary hammer with a ½” masonry drill bit, drill two holes in the floor
through the holes in the base angle weldment (see parts list).
4. Install the anchor bolts and torque them to 150 ft
⋅
lb.
5. Install the ½”DIA x 5” carriage bolts under the rear of the deck (left and right of the
pull-out pan). Adjust the bolts so that the deck is level when fully collapsed.
6. POSITIONING INSTRUCTIONS
NOTE:
Please review the safety instructions and the safety card attached to the stand.
Inspect the lift for mechanical fitness before using.
1. Plug the electric utility cord into an approved 115V outlet.
2. Pull out the approach ramp from the pull-out pan and lower onto the ground.
3. Roll the vehicle onto the lift.
Vehicles must never be driven onto the lift
.
4. Using tie down straps, secure the vehicle to the lift.
NOTE:
When positioning the motorcycle on the lift, take time to equalize the load front-
to-rear and side-to-side. Some vehicles may require additional assistance when
loading and unloading. Always restrain vehicle to lift using proper tie down
straps.
