USAGE TIPS:
• For most effective cleaning, keep spray nozzle from 8 to 24 inches away from
cleaning surface.
• If you get spray nozzle too close, especially using high pressure mode, you may
damage surface being cleaned.
•
DO NOT
get closer than 6 inches when cleaning tires.
SHUTTING DOWN THE PRESSURE WASHER
The Pressure Washer motor runs only when the trigger is engaged. To shut off the
Pressure Washer:
1. Release spray gun trigger.
2. Move unit's ON/OFF switch to OFF position.
IMPORTANT:
Releasing the trigger will shut off the motor but does not shut off
electrical power to the unit.
3. Remove and store quick change pressure washer tip.
4. Turn off water supply.
5.
ALWAYS
point spray gun in a safe direction and squeeze spray gun trigger to
relieve built up pressure in the unit.
Spray gun traps high water pressure, even when motor is
stopped and water is disconnected.
6. Engage trigger lock on spray gun when not in use. Place the gun in its holder
on the side of the unit.
7. Disconnect GFCI plug from outlet and wrap power cord around the Power Cord
Hook at the back of the pressure washer. Store the GFCI plug inside its housing
in the center of cord intake.
8. Disconnect pressure washer from water supply and store the unit (see MAINTE-
NENCE section).
16
15
Turbo Nozzle :
This nozzle circulates a powerful spray into a
circular pattern to provide greater cleaning efficiency over
large areas.
ATTACHING NOZZLES TO SPRAY WAND
Never place hands in front of nozzle. Never grasp hose or fittings during
Pressure Washer operation.
Never attempt to attach or remove spray wand or
hose fittings while Pressure Washer system is pressurized.
Turn off Pressure Washer and lock the Gun Trigger
before attempting to
change pressure nozzles.
Nunca coloque las manos delante de la boquilla. Nunca tome la manguera
ni las uniones durante el funcionamiento de la lavadora a presión.
Nunca intente conectar ni retirar el tubo de rociado o las uniones de la
manguera mientras el sistema de la lavadora esté presurizado.
Apague la lavadora y trabe el gatillo
antes de cambiar las boquillas a presión.
A. To attach, pull back on slip ring and insert nozzle
until it securly snaps into place.
B. To detach, slide down slip ring on female quick-
disconnect to eject the nozzle.
6. Hold the gun securely with both hands. Point the gun in a
safe direction. Make sure that the gun safety (the button
above the trigger) is unlocked and squeeze the trigger to
allow any air that is trapped inside the unit and hoses to
escape. Continue to squeeze the trigger until a steady
stream of water comes from the nozzle.
7. Turn on the ON/Off switch on the front of the
Pressure Washer.
NOTE:
Motor does not start until
trigger is pulled.
8. Point the gun in a safe direction and squeeze the
trigger to start motor and water flow.
When using Pressure Washer on
uneven surfaces, lock rear wheels to prevent unintended
movement.
Make sure wand is
SECURELY tightened to Gun. If the wand is
not securely locked into place, it could be
ejected under high pressure when operating
the gun, possibly causing injury or damage.
Cerciórese de que el
tubo esté FIRMEMENTE apretado en la
pistola. Si no está firmemente trabado en
su lugar, el tubo podría ser expulsado a alta
presión al operarse la pistola y posiblemente
causar lesiones o daños.
PUSH
SQUEEZE
Press ON
SLIP RING