Smoothskin Bare FIT, User Manual

Page: 11 / 73

20 21
Always perform a patch test on each new treatment area
Observe for adverse
events
12
24 HOURS
1
2
3
4
5
6
7
8
9
10
11
Step 3: Treating with SmoothSkin Bare Fit
a) Plug the Power Supply into an Electrical Outlet using the provided Power Cable. The Skin Tone Sensor on the front of the
Handset will illuminate blue and the fan will start up.
STANDBY MODE Timeout
When the unit is left “inactive” i.e. no buttons are pushed for 10 minutes then the unit will revert to STANDBY mode,
and the STS lights will switch off. To return to READY mode for treatment, press the Activation Button.
b) Press the Handset firmly against the area to be treated ensuring the Skin Tone Sensor is in contact with the skin. If the Skin
Tone Sensor does not detect a valid skin tone, then the Handset cannot be activated. When the Skin Tone Sensor measures a
valid skin tone, the lights around the Activation Button will illuminate WHITE to indicate the device is ready to flash.
Incorrect Correct
Skin Detection
Indicator On Indicator Off
No Skin Detection
Treatment Window
8. HOW TO USE SMOOTHSKIN BARE FIT
WARNING: Follow each step in the treatment process ensuring you complete all aspects of each step before progressing to
the next.
Step 1: PREPARE the area to be treated
Remove all visible hair by shaving. Make sure there is no hair remaining above the surface of the skin as this may cause injury.
This also prevents debris from covering the front of your device.
Cleanse the treatment area and pat dry. Remember, don’t use any gels or creams with this device!
Step 2: Doing a TEST PATCH
Before your first treatment on each new body area, we RECOMMEND you test your skin in that area for a reaction to
SmoothSkin Bare Fit. The patch test area should be approximately 3cm x 2cm in size (equivalent to 2 flashes applied to the
skin side by side). Follow Step 3 to treat the area.
Wait 24 hours following the patch test , to ensure your skin is suitable for treatment and there is no adverse reaction to the
light energy. If there is no reaction after 24 hours, you may treat the area around the patch test. The ‘patch tested area’ should
NOT be re-treated for at least 1 week.