®
GT4
6
8. CLEANING
Do not use cleaning agents as they could harm the o-rings.
Before assembling, check the completeness and positioning of the o-rings to prevent leakage of liquid.
• Disassemble the device into its components.
• Clean the components (not the cotton) with warm water or in an ultrasonic bath.
• Completely dry the components before reassembling the device.
9. MAINTANANCE
• Wait until the device has completely cooled down before disassembling, to prevent burns.
• Make sure that there is no power supply by unscrewing the device from the mod or by switching off the mod.
ASSEMBLING DEVICE
• The device is usually delivered fully assembled, the following instructions are for the assembly after cleaning.
• Moistening the sealing rings with liquid makes the assembly easier.
Three hexagon socket screws (4) are screwed into the positive pole
(2) with the help of a suitable hexagon wrench.
Three hexagon socket screws (4) are screwed into the
deck (1) with the help of a suitable hexagon wrench.
The hexagon socket screw (5) will be
screwed into the base (1).
The insulator (3) is placed inside the base (1).
The positive pole (2) is now placed on the insulator (3),
The insulator (11) is plugged onto the positive pole screw (12).
The screw is now pushed from the bottom through the base (1)
and screwed into the positive pole (2). The screw (11) should be
tightened to seal the deck.
2
3
4
