Grill Assembly
Locate:
• Barrel Lid
• Lid Handle
• Nameplate
• Heat Indicator
• (2) Barrel Lid Hinges
• (6)
¼
”
–20 x .59
”
bolts
• (4)
¼
”
Hex Nuts
• (2) Handle Gaskets
• (4) M5 Hex Nuts
• (2) Lid Hinge Pins
• (2) “R” Clips
Locate:
• Electronic Ignitor
• Electronic Ignitor Bracket
• Battery
Ignitor
Bracket
Plastic Hex
Nut
Ignitor
Button
Battery
Step 1:
Attach Lid Handle with
Handle Gaskets to Barrel Lid
with (2)
¼
”
–20 x .59
”
bolts.
Attach Heat Indicator and
Nameplate to Barrel Lid
with (4)
M5
Hex Nuts.
Note: Some Models
may not have a
Heat Indicator.
Step 2:
Attach Barrel Lid
Hinges as shown with
(4)
¼
”
–20 x .59
”
bolts
and (4)
¼
”
Hex Nuts.
12. Barrel Lid Assembly
11. Electronic Ignitor Assembly
Step 1:
Remove the Ignitor Button
and Hex Nut from the Ignitor.
Assemble the Electronic Ignitor
to the Ignitor Bracket as shown.
Step 2:
Feed the ignitor wire from the side burner through the
small hole in the left side of the Control Panel and attach
to Electronic Ignitor. Connect the (2) Ignitor wires from the
main burners to the Electronic Ignitor (
Note: 3-Burner Grills
will have only 1 wire
). Place the Electronic Ignitor with bracket
to the backside of the Control Panel so that the threaded
part comes through the Control Panel face.
Step 3:
Secure in place with the Plastic Hex Nut
and then insert the battery into the
ignitor with positive end facing out.
Attach the Ignitor Button to the Ignitor.
Connect Ignitor wire from main burner
to the previously attached Piezo
ignitor from below Control Panel.
Step 3:
Attach Barrel Lid to Barrel Base with
(2) Hinge Pins and (2) “R” Clips as shown.
M5 Hex
Nuts
Instructions for 3 & 4-Burner Grills
For 2-Burner Grills Only
16
