WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
XRC 3.0 3,000lb Winch
Part # 97203
Handle Bar Switch Assembly
When installing your ATV winch system, read and follow all mounting and safety instructions.
Always use caution when working with electricity and remember to verify that no exposed electrical
connections exist before energizing your winch circuit.
To install the complete kit, you will need to mount the winch, contactor handlebar mounted mini-
rocker switch and remote socket. Mounting locations may vary depending on the make and model
of the ATV. Read and understand the following instructions to choose the appropriate mounting
locations.
It is recommended that the switch be installed on left handlebar. A piece of electrical tape around
the handlebar will help prevent rotation of mount on the handle bar. Do not tighten over and hoses
or cables. Once the handle bar switch is mounted, route the two bullet terminal wires back to where
the contactor will be mounted. Splice the end of the red 20ga wire to key controlled electrical wire of
the ATV. Using a test light, locate a suitable wire from the ATV key switch. The wire should only
have power when the key is in the “ON” position.
