WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
XRC 3.0 3,000lb Winch
Part # 97203
GENERAL TIPS FOR SAFE OPERATION
The XRC3.0 is rated at 3,000lbs capacity when spooling the first layer on the drum. Overloads can
damage the winch/motor/or wire rope. For loads over 50% we recommend the use of a
pulley/snatch block to double the wire rope line. This will help in two ways, 1) reduce the number of
rope layers on the drum, 2) reduce the load on the wire rope by as much as 50%. When doubling
the line back to the vehicle, attach to the frame or other load bearing point.
The vehicle engine should be kept running during operation of the winch to minimize battery drain
and maximize power and speed of the winch. If the winch is used for a considerable time with the
engine off the battery may be drained and too weak to restart the engine.
Get to know your winch before you actually need to use it. We recommend that you set up a few
test runs to familiarize yourself with rigging techniques, the sounds your winch makes under various
loads, the way the cable spools on the drum, ect….
Inspect the wire rope and equipment before each use. A frayed or damaged cable should be
replaced immediately. Use only manufacturer’s identical replacement cable with the same
specifications.
Inspect the winch installation and bolts to ensure that all bolts are tight before operation.
Never connect the cable back to itself. This will cause cable damage. Always use a snatch block,
sling or chain of suitable strength as shown the illustrations.
Store the remote control inside your vehicle in a place that it wont get damaged.
Any winch that appears to be damaged in any way, is found to be worn, or operates abnormally
need to be removed from service until repaired. It is recommended that the necessary repairs be
made by an authorized winch repair facility.
Pull only on areas of the vehicle as specified by the vehicle manufacturer.
Only attachments and/or adapters supplied by the manufacturer should be used.
