Correct installation
Incorrect installation
Caution
The mounting accessories provided can only be used for solid walls as shown in the drawing above.
Improper installation may cause the water heater to dislodge.
If the walls do not meet the minimum
standards for bearing the water heater load,
increase the mounting reinforcement
accordingly.
Ensure the power cord is installed above the
inlet and outlet. Installation below this point
may cause water to flow down the cord to the
power source, leading to accidents.
Plumbing connection
Do not alter the installation position or block the relief valve. Connect the safety valve provided with this
unit to the inlet of the water heater (inlet pipe has a blue cap). The arrow points to the direction of
water flow (to the heater). The safety valve must be connected to the discharge pipe, mounted
downwards to a floor drain in a frostless environment. As water may drip from the discharge pipe
during operation of the heater, a floor drain should be provided nearby. The pipes should not be
blocked.
11
Fig. 3
Fig. 4
Fig. 5
