S E C T I O N 6
•
O p e r a t i o n
HOTLINE
®
3 Blood and Fluid Warmer | Operator’s Manual
13
SECTION 6
Operation
This section describes the controls and displays that monitor and control
the HOTLINE
3 Warmer, and the modes of operation.
Controls and Displays
• Display Panel
• Power and Alarm Test Buttons
• Reservoir Level Display
Display Panel
The Display Panel is located on the front of the HOTLINE
3 Warmer
and provides continuous information about the operation of the
HOTLINE
3 Warmer. A liquid crystal display (LCD) indicates
recirculating solution temperature. Just below the LCD, four light-
emitting diodes (LEDs) indicate operation modes for the HOTLINE
3
Warmer.
1
Recirculating Solution Temperature - The temperature is displayed
in degrees Celsius.
2
ON/Operation - The green LED illuminates when the power is
turned on and the HOTLINE
3 Fluid Warming set is properly
installed.
3
Check Disposables - The red LED illuminates and an audible
attention signal beeps when the HOTLINE
3 Fluid Warming Set
is not properly installed.
4
Add Recirculating Solution - The red LED illuminates and an
audible attention signal beeps when the level in the reservoir is low
and additional recirculating solution must be added.
5
Over Temperature - The red LED illuminates and an audible
warning signal beeps when the recirculating solution is over the
acceptable temperature for safe use.
1
2
3
4
5
