Smitec FLXMOD MST S4 Series, Installation, Use And Maintenance Manual

Page: 24 / 32

FLXMOD MST S4 series Installation, use and maintenance manual - EN
Ver. 1.01 24
9
Installation
9.1 Assembly
The MST S4 module, like all modules belonging to the FlxMod system, are fixed to a DIN rail by means of a
spring-loaded coupling system.
In the FlxMod system, functional grounding (FE) is simply performed by hooking the module to the DIN rail.
Below is an example image:
During installation of the FLXMOD MST S4 computer, falls and violent shocks must be
avoided which could compromise the smooth operation.
Avoid touching the input / output connectors on the computer panel directly unless you are
equipped with suitable static electricity protection equipment; any discharges on the con-
nectors could damage the appliance.
Always carry out all electrical connections when the equipment is switched off: this will pre-
vent damage to the computer and danger to the operator (exceptions to connections to the
USB ports are possible).
Always make sure that all the devices connected to the MST S4 have an efficient grounding
(if foreseen by the device). Failure to follow this precaution could result in damage to the
computer and danger to the operator.
Do not position the device so that it is difficult to disconnect the wiring connected to it.