Problem
Possible cause
Solution
Food products prevent that
water flows into the water
collector.
Make sure that food prod-
ucts do not touch the rear
plate.
Water flows on the floor.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
Attach the melting water out-
let to the evaporative tray.
The temperature in the appli-
ance is too low/too high.
The temperature regulator is
not set correctly.
Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The food products' tempera-
ture is too high.
Let the food products tem-
perature decrease to room
temperature before storage.
Many food products are stor-
ed at the same time.
Store less food products at
the same time.
The thickness of the frost is
greater than 4-5 mm.
Defrost the appliance.
The door has been opened
often.
Open the door only if neces-
sary.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
Replacing the lamp
Disconnect the plug from the mains socket.
1.
Remove the screw from the lamp cover.
2.
Remove the lamp cover (refer to the
illustration).
3.
Replace the used lamp with a new lamp
of the same power and specifically
designed for household appliances (the
maximum power is shown on the lamp
cover).
4.
Install the lamp cover.
5.
Tighten the screw to the lamp cover.
6.
Connect the plug to the mains socket.
7.
Open the door.
Make sure that the light comes on.
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to
"Installation".
3.
If necessary, replace the defective door
gaskets. Contact the Authorised
Service Centre.
11
