Smeg UD505DSUK, User Manual

Page: 12 / 29

10
Using the buttons
Button Short press
Pressed for 2” Pressed for 5”
Long press, release, press
again
Display temperatures
Boiler and tank
On/OF
Door open and machine OFF.
Long press >>> display reads
“- -“ >>> release and press
again: Access Setup Menu (1)
Scroll through Setup
options (2)
Start Pump-out Total pump-out (tank+boiler)
Set Short Programme
Start Short Programme
Set Medium Programme
Start Medium Programme
Set Long Programme
Start Long Programme
Set P0 (Empty tank)
Start P0
Door closed
Peristaltic pumps in Manual
mode to prime pipes
Reset to DEFAULT
parameters (1)
Technician user only
1) Restores the default parameters, for new settings see point (6.3)
A series of operations can be carried out when the dishwasher is first installed to customise it to the user's requirements.
6.1 Contents of display
The display provides the following information:
• Machine off but energized: OFF
• Machine on and ready for use: End/P1-P2-OP3
• Wash phase: ||||||||||
• Programming phase: See parameter programming section
• Error message: See error messages section
6.2 Note on display of temperatures
Temperatures shown on the display might not indicate the actual temperature in the tank and/or boiler during heating - wait
about 1’ after the heating elements switch off to see the real temperature.
6.3 Parameter programming procedure (setup)
To modify the parameters, proceed as follows starting with the appliance in “OF” status with the door open.
1) Switch the appliance using the On/OF button
2) Press and hold the button until the display shows “- -“ , release and press again.
3) Press the pump-out button to scroll through the parameters for modification
4) Modify the parameter by pressing button P1
5) During setup operations, the description and value of the parameter alternate on the display.
6) Select the other parameters for modification in the same way and proceed as described above
7) To exit the setup menu press and hold until the display shows “OFF”, press P2 or P3 or wait at least 3 minutes
without pressing any key; in this way the machine automatically exits the setup menu.