Smeg STO905U, Instruction Manual

Page: 48 / 91

Rev 0.0
29
USER INSTRUCTIONS EN
5.2 Cleaning the water intake fi lter
The water intake fi lter located at the outlet of the water supply tap needs to be
cleaned periodically. After having closed the water supply tap, unscrew the end
(ref. A fi g. 5-01) of the water intake hose (use a pair of pliers, if necessary), and
clean it delicately carefully, screw the water intake hose back into position (ref.
A fi g. 5-01) (use a pair of pliers, if necessary).
A
5.3 Cleaning the spray arms
The spray arms can be easily removed for periodic cleaning of the nozzles,
to prevent possible clogging. Wash them under running water (at room tem-
perature) and carefully replace them in their seats,
checking that their rotary
movement is in no way impeded ; if this is not the case, make sure they have
been mounted properly.
Removing the spray arms
To remove an upper spray arm (ref. A fi g. 5-02), unscrew the locking ring
(ref. B fi g. 5-02) by turning it clockwise. After cleaning, remount the spray
arm in its seat and tighten the locking ring by turning it anti-clockwise.
To remove a
lower spray arm (ref. A fi g. 5-03), simply lift it up, pulling by the
central part (see fi g. 5-03). To remove the orbital spray arm assembly (ref. B
fi g. 5-03), take hold of the lower arm (ref. A fi g. 5-03) and pull the orbital unit
upward (see fi g. 5-04). After cleaning, remount the orbital spray arm in its
seat and push it down slightly until it clicks into place on the lower spray arm.
Then remount the lower spray arm into its seat and push it down slightly until
it click into place (see fi g. 5-03).
•
•
Fig. 5-01