User instructions
14
TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT
•
Always try to run the dishwasher fully loaded.
•
Do not wash the dishes in running water.
•
Use the washing program that is most appropriate for each type of
load.
•
Do not carry out any preliminary rinsing.
•
If available, connect the dishwasher to a hot water supply up to 60°C.
TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT
THE ENVIRONMENT
The phosphates contained in dishwasher detergents are harmful to the
environment. To avoid using excessive amounts of detergent and to save
on electricity, observe the following:
•
separate the more delicate items from dishes that are more resistant
to aggressive detergents and high temperatures;
•
do not pour the detergent directly on the dishes.
If the door has to be opened while washing is in progress, the program
will be interrupted. The relative light will keep flashing and a beeper will
signal that the cycle has not been completed.
After the door has been
closed, especially if the water is hot, the dishwasher will wait for up
to 90 seconds before restarting the program
. This operation should
only be carried out if strictly necessary, because it might cause problems
in execution of the program or a water spill from the front edge.
END OF CYCLE
At the end of the washing cycle the dishwasher
gives a short acustic signal and the program
indicators
nr
4
and
5
start blinking (the word
"end" is displayed on the window).
To switch off the dishwasher, open the door and press the
ON/OFF
button
(1)
.
REMOVING THE DISHES
At the end of the washing program, wait at least
20 minutes
before
removing the dishes, to allow them to cool down. To prevent any water
droplets on the upper basket from falling on the dishes in the lower
basket, it is
advisable
to unload the lower basket first, and then the
upper basket.