EN
30
Rev. 0.1
5.2
Cleaning the water intake fi lter
Clean the water inlet fi lter at regular intervals. After closing the delivery tap,
unscrew the ring nut (ref. A fi g. 5-01) on the water inlet pipe (using a pair of pli-
ers, if necessary) and delicately clean the fi lter, removing deposits or impurities.
Then fi rmly fi x the pipe by tightening the ring nut (ref. A fi g. 5-01) (use a pair of
pliers, if necessary).
A
5.3
Cleaning the spray arms
The spray arms can be easily removed for periodic cleaning of the nozzles,
to prevent possible clogging. Wash them under running water (at room tem-
perature) and carefully replace them in their seats,
checking that their rotary
movement is in no way impeded
; if this is not the case, make sure they have
been mounted properly.
Removing the spray arms
• To remove the
upper
spray arm (ref. A fi g. 5-02), unscrew the locking ring
(ref. B fi g. 5-02) by turning it clockwise. After cleaning, remount the spray
arm in its seat and tighten the locking ring by turning it anti-clockwise.
• To remove the
orbital
spray arm assembly (ref. A fi g. 5-03), take hold of the
lower arm (ref. B fi g. 5-03) and pull the orbital
unit upward (see fi g. 5-03).
After cleaning, remount the orbital spray arm in its seat and push it down
slightly until it clicks into place on the lower spray arm (see fi g. 5-03). Then
remount the lower spray arm into its seat and push it down slightly until it
click into place (see fi g. 5-03).
Fig. 5-01
USER INSTRUCTIONS
Summary of Contents for ST8646U
Page 2: ......
Page 4: ...EN 2 Rev 0 1...
Page 33: ...EN Rev 0 1 31 A B Fig 5 02 Fig 5 03 USER INSTRUCTIONS...
