8
Pan Detection
If a pan is removed from a surface cooking area when it is in
use, the No Pan indicator light will glow, the No Pan symbol will
appear in the display, and a signal tone will sound for 1 minute.
If the pan is not replaced within 1 minute, the surface cooking
area will turn Off.
If a timer is running when a pan is removed, the countdown
will pause.
Control Lock
The Control Lock avoids unintended use of the surface
cooking areas.
If Control Lock is activated when power to the cooktop is
off, the cooktop is locked out, and the surface cooking areas
cannot be turned on by the cooktop touch controls.
If Control Lock is activated when power to the cooktop is
on, all keypads are locked out except for the Power keypad.
To Lock Cooktop:
Touch and hold CONTROL LOCK for 3 seconds. After
3 seconds, a tone will sound and the indicator light
above the Control Lock keypad will light, indicating
that the cooktop controls are in the lockout position.
If the cooktop is in use when Control Lock is activated,
cooking will proceed as normal and any timers that have
been set will continue their countdown.
To Unlock Cooktop:
Touch and hold CONTROL LOCK for 3 seconds.
Performance Boost Function
This function allows you to increase the heat setting level
above the maximum heat setting 9 for 10 minutes or less.
NOTE:
Performance Boost function is not available when
the Bridge function is activated.
Performance Boost function is available on only 1 surface
cooking area at a time within a zone. If you attempt to use
another surface cooking area in the same zone, “P” and “9” will
briefly flash in the display before returning to heat setting level 9.
The surface cooking area that was set to the Performance
Boost function will automatically reset to heat setting level 9.
See the following illustrations for zones.
Zone 1
Zone 2
P
P
P
P
Power Boiling Simmer Melt
B Control
Lock Pause
TIMER
BOIL
SIM
MELT
BOIL
SIM
MELT
SIM
MELT
SIM
MELT
A
D
B
C
A. Zone 1—Left rear
surface cooking area
B. Zone 1—Left front
surface cooking area
C. Zone 2—Right front
surface cooking area
D. Zone 2—Right rear
surface cooking area
To Use:
1.
Check that a surface cooking area has been selected.
2.
Touch the “+” keypad on the Heat Level slider. “P” will
appear in the display.
3.
Touch the “+” keypad on the Heat Level slider when finished.
The “P” will no longer be visible in the display, and the
Performance Boost function will no longer be active. The
surface cooking area turns back to heat setting level 9.
NOTE:
The Performance Boost function may automatically
deactivate to keep the internal electronic components of
the cooktop from becoming too hot.
Timer
Use the cooking timers to set times up to 90 minutes. The timers
are independent of any other control settings.
To Use:
1.
Check that a surface cooking area has been selected.
2.
Touch the Timer “+” keypad. “01” will appear in the
timer display for the surface cooking area selected.
3.
Touch the Timer “+” keypad to increase the time in
1-minute increments.
OR
Touch the Timer “-” keypad to decrease the time in
1-minute increments.
4.
The timer will start to count down after a few seconds.
To change the time, touch the Timer “+” or “-” keypads.
5.
When the countdown is finished,”00” flashes and a tone
will sound.
NOTE:
When the power is restored after an outage, the timers
will no longer be running.
A
A. No pan symbol
